ˆ
  

Wet Caverns 2: Low Corridors



This set of 3D-printable terrain adds on to sets like Wet Caverns 2 and Wet Caverns 2: Low Walls so you can join up multiple wet caverns¸ using wet corridors in between! Compared to full-height cavern pieces¸ these lower wet corridors are: Faster to print Easier to see over Easier to place miniatures close to -- especially important for tight corridors! These corridors work well with both half-height and full-height caverns; the convenience of using low walls for narrow corridors can't be overstated. Sample corridor complex:


Please note: The names of all or most of the games and their logos on the subsequent pages are trademarks or registered trademarks of the owning company. Any use on this or subsequent pages should not be misconstrued as a challenge to said trademarks, nor as an attempt to infringe upon any copyrights that may be owned by said companies.
DatenschutzerklärungPrivacy Policy , Impressum, Disclaimer, © CopyrightLegal notice, Disclaimer, © Copyright 1994-2021 by Dogio