Tower Add-On 2
This set includes a number of tower walls and floors to expand the selection in the FDG Tower of Terror set and the prior Tower Add-On 1 set. The two new styles are: Tower walls with castle floors on the inside¸ and village sidewalk on the outside¸ for towers as part of a village map Tower walls with castle floors on the inside¸ and dirt/grass on the outside¸ for outdoor towers Each style includes a wall¸ doorway¸ wall with arrow slits¸ wall with windows¸ and a piece with a trapdoor in the floor (because what's a tower without a dungeon underneath?) Recommended Print Settings: Layer Size : 0.15mm¸ or 0.1mm for finer detail Infill : 10% for all models recommended¸ especially thin posts and door frames Top/Bottom Layers : 6 (or 0.9mm if using a different layer size than 0.15mm) Side Shell Count : 2 (or 0.8mm if using a different nozzle size than 0.4mm) Raft/Brim/Supports : none; though a brim is recommended if the corners curl up during printing Related Sets: Tower of Terror -- the base tower set including upper-level tower pieces Tower Add-On 1 -- other ground-floor and in-dungeon tower options